Fits: 1971-74 B Body with AAW510691 Kit
Fits: 1968-70 B Body with AAW510634 Kit
This kit was designed for wiring systems that will be combined with a high output alternator. Each kit comes with 12 feet of 6 gauge charge cable, ring terminals, alternator boot, 200 amp megafuse and shrink tubing. Includes detailed installation instructions.
Innovative automotive style fuse
Protect a high-draw circuit with the 60 amp fuse kit.
Socket is designed to snap fit into a 3/4 inch hole. Socket must be grounded. Uses a standard 1156 type bulb.
Courtesy Light Connection Kit
The 11 volt module can be used to trigger an in-dash warning light when charging system voltage drops below 11 volts.
Retained Accessory Power Relay Pack
Single Electric Cooling Fan Dual Relay Kit For
Universal 70 Amp Relay Kit
Our hi-torque starter bypass wire should be used when adding an upgraded 12 volt ignition and or hi-torque/1 post starter to a pre-’67 vehicle. The bypass wire prevents the ignition coil from sending power to the starter while the engine is running. Includes detailed installation instructions.
Fits: 1968-70 B Body with AAW510634 Kit
INDICATOR LIGHT- LED green. Light snap mounts into a .250" hole
(1/4) . Raised lens and black bezel.
INDICATOR LIGHT- LED red. Light snap mounts into a .250" hole (1/4) Raised lens and black bezel.
This external jump start block provides easy access when reaching the battery is difficult or space is limited.
This ATO power tap kit can be used with any Classic Update or universal kit utilizing a GM-style fuse box. Easily add battery, ignition and accessory power taps from the face of the fuse panel.
Eight wire bulkhead grommet and connector kit. Requires a 1 1/2" mounting hole. Includes male and female terminals.
Four wire bulkhead grommet and connector kit. Requires a 1 1/4" mounting hole. Includes male and female terminals.
Nine wire bulkhead grommet and connector kit. Requires a 1 3/4" mounting hole. Includes male and female terminals.
Six wire bulkhead grommet and connector kit. Requires a 1 3/8" mounting hole. Includes male and female terminals.
Female 4 way 56 series with terminals.
CONNECTOR HOUSING GM Back-up light connector. with female terminals
Male 4 way 56 series with terminals.
GROUND STRAP-6" LONG-3/8 inch ring terminal factory crimp.
GROUND STRAP-12" LONG-3/8 inch ring terminal factory crimp.
GROUND STRAP, 12 in., medium duty, 3/8" bolt hole on both ends.
GROUND STRAP, 18 in., medium duty, 3/8" bolt hole on both ends.
Boot is 1-5/16 inches long with two single wire holes. 3/4 inch inside diameter.
Fits a 7/8 inch hole and has a 7/16 inch wire opening.
Fits 1.0 inch hole and has a two wire opening. Center of grommet may be drilled out to a larger size if needed.
Fits 1 1/4 inch hole and has a 7/32 inch wire opening.
Fits 1 1/2 inch hole and has a 1 5/32 inch wire opening.